Unique-Bargains 2Pairs 16x13x6mm 153A Carbon Brushes

Replacement Carbon Brushes for Hammer Drills

These carbon brushes are direct replacements for worn motor brushes in electric hammer drills. Each pack contains two pairs with wire leads and springs already fitted. They restore motor contact when the original brushes have worn down and the tool runs poorly or stops. The dark-grey carbon blocks measure 16 mm by 13 mm by 6 mm with a total length of 46 mm.

Low-Friction Carbon Contact Runs Cool

The carbon-to-commutator interface generates minimal heat during normal drilling operation so the motor maintains its normal temperature. No extra lubrication or polishing is required and the supplier advises against any surface treatment. The pre-attached springs maintain consistent pressure without audible chatter. Current capacity is rated at 153 A for the brush material itself.

Simple Two-Pair Pack Fits Standard Holders

Each brush slides into the motor’s existing brush holders without modification to the tool. The 1.8-inch overall length clears standard caps and the supplied leads connect to the original terminals. Two pairs cover both brush positions in a single-service visit. Builders needing a different cross-section or a brush without leads will need a different part.