SXDOOL PCI-E 6Pin to 3 x DC 5.5 x 2.5mm Power Adapter Cord 12V 18AWG 1M
- Case Fan Accessory
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a USB-C PD charger to MagSafe 2 MacBook Pro 13, 15 and 17 inch models from Mid 2012 onwards, delivering up to 100W
This adapter converts a USB-C female port into a MagSafe 2 T-Tip connector for Apple MacBook Pro models from 2012 onwards. It supports 13, 15 and 17 inch Retina Display variants including A1398 and A1424. The cable uses TPE material and carries a white finish.
The adapter requires a USB Power Delivery source supplying 15V to 20V at 3A to 5A. Maximum output to the MagSafe 2 tip is 100W. The supplier recommends using an Apple 87W original charger or a single-port PD charger of equal or higher rating to meet the power requirement.
At full 100W the adapter can charge the largest supported MacBook Pro models under load. It cannot supply power beyond the PD source capability or the MagSafe 2 connector rating. Buyers needing to charge devices without MagSafe 2 ports or requiring multiple simultaneous outputs cannot use this cable.
Measured against everything we stock in Jumper & Adapter Power Cords, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The T-tip connector fits MacBook Pro 13, 15 and 17 inch Retina models from mid 2012 onward, matching Apple part numbers A1398, A1424 and MD506LL/A.
The cord can pass up to 100 W at 15–20 V from a USB-C PD charger to the MagSafe 2 port, so the laptop draws whatever power it needs up to that ceiling.
The adapter needs a PD source supplying 15–20 V at 3–5 A; a single-port charger rated 87 W or higher is recommended to deliver the full 100 W to the MagSafe 2 tip.
More in Jumper & Adapter Power Cords
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?