We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five copper-coloured plasma drag tips with moulded nylon insulation

Victor Thermal Dynamics

Victor Thermal Dynamics 9-8252 60A Drag Tip PK5

SKU CH-3W1E-C9HFD

A pack of five 60 Amp drag tips for Thermal Dynamics 1 torches

  • Product typeWelding Supplies
  • 60 A drag-tip rating for consistent plasma cuts
  • Molded nylon body resists heat and wear
  • Designed for Victor Thermal Dynamics 1 torch
  • Pack of five tips reduces downtime

Victor Thermal Dynamics 9-8252 60A Plasma Tips

This pack contains five drag tips rated for 60 amp plasma cutting. The tips are moulded from nylon and designed for use with Thermal Dynamics 1 Torch systems. They provide a direct replacement for worn consumables in compatible setups. Each tip supports drag cutting technique at the specified amperage.

Suited for operators running Thermal Dynamics 1

Buyers using a different torch model or requiring a different amperage rating should verify compatibility before purchase. The package quantity is fixed at five pieces and cannot be split. Those needing alternative tip geometries or single-unit purchases will need to source them separately.

How it compares

Measured against everything we stock in Welding Equipment & Positioners, at today’s prices. Recalculated every night.

Price $57.99
Typical for this category: the median of 1,978 items is $50.99.

Specifications

Product
Brand nameTHERMAL DYNAMICS
Product typeWelding Supplies

Questions about this item

Which torch model is required for the 60 A drag tip to fit?

The tip is designed for the Thermal Dynamics 1 Torch; it will not seat correctly on other torch models.

Can the 60 A drag tip be used with a power source rated below 60 amps?

Yes, it will operate at lower amperage, though cut quality and speed will be reduced compared to running at the rated 60 A.

More in Welding Equipment & Positioners

Similar items