STARTECH DB92422 RS422 RS485 DB9 to 5 pin terminal block data converter
- DB9 to Terminal
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts USB 2.0 to SMBus and I2C with eight configurable GPIO pins and a 512-byte data buffer
The Vszerda CP2112 is a USB 2.0 full-speed bridge that converts USB traffic to SMBus or I2C for sensor evaluation and prototype development. It draws power from the USB bus at 4.0 to 5.25 V or can be self-powered at 3.0 to 3.6 V. Eight GPIO pins are configurable as input, output, open-drain or push-pull, and a 194-byte OTP ROM stores custom product data.
Engineers who need high-speed USB throughput beyond 12 Mbps will find the full-speed link insufficient. Projects that require a UART, SPI or CAN interface instead of SMBus/I2C cannot use this module. Designs that must operate outside the -40 °C to 85 °C range or at I/O voltages below 1.8 V are not supported.
The bridge complies with the USB 2.0 full-speed standard at 12 Mbps and provides a 512-byte SMBus data buffer with a configurable 7-bit slave address. This throughput and buffer depth determine whether the module can sustain the sensor polling rate your application demands.
Measured against everything we stock in Serial & Protocol Converters, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The link runs at USB 2.0 full speed, so the practical throughput is limited to 12 Mbps regardless of the host port version.
The board uses a MicroUSB 2.0 connector compliant with the USB 2.0 specification, capping the connection at full-speed 12 Mbps.
The I/O voltage can be set from 1.8 V up to the VDD supply level, so the bus must remain inside that window.
More in Serial & Protocol Converters
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?