Vszerda PCIe 4.0 X1 Riser Cable 10cm 36-pin 90° dual angle

What this cable does and who needs it

This PCIe 4.0 x1 riser cable extends a PCIe x1 slot by ten centimetres with a dual 90-degree connector layout. It suits builders who must route a card into a confined chassis or behind a motherboard tray where a straight connector will not fit. The open-ended female end accepts x1, x4, x8 or x16 cards, though bandwidth remains limited to x1 speeds. It is not for buyers who need full x16 throughput or multiple simultaneous devices.

How it fits into a build

The male plug inserts into any standard PCIe x1 slot on the motherboard, while the female receptacle sits at a right angle to accept an expansion card. No extra power connectors or active electronics are required; the cable draws power directly from the slot. Its flexible construction and bolt-reinforced PCB allow tight bends without stressing solder joints. It does not replace a dedicated riser kit for vertical GPU mounting in large cases.

Thermals noise and power draw

The cable is completely passive, adding no fan noise and drawing no additional power beyond what the attached card consumes through the slot. TPE shielding with PE insulation suppresses electromagnetic interference, keeping signal integrity stable at the rated 16 Gbps line rate. Operating temperatures follow the host system ambient conditions; no thermal throttling or active cooling considerations apply.