Vszerda SAS 4.0 SFF-8654 8i 74pin Host to Target Cable 50cm

What this cable does and who needs it

This Vszerda cable connects a host controller with an SFF-8654 8i 74pin connector to a target device using the same interface. It supports SAS 4.0 and PCIe Gen3 signalling at 24Gbps per channel across four lanes. The 50cm length suits dense server, storage or workstation chassis where space is limited.

What to verify before ordering

Confirm both ends of your link use the SFF-8654 74pin form factor, often labelled Slim SAS 8i or Slimline SAS. The cable is male-to-male, so each port must accept a plug rather than a receptacle. Ensure your backplane or controller specifies SAS 4.0 or PCIe Gen3 compatibility for the intended data rate.

Build quality and daily handling

The black shielded assembly uses a high-speed design with 148 total contacts across the two connectors. Its slim profile reduces cable bulk and eases routing in tight drive bays or between expansion cards. The straight 74pin plugs insert with a firm click and stay seated under vibration typical of rack-mounted equipment.