Athena Power AP-P4ATX60FE 600W server power supply
- 600 W
- Single
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement 290 W unit for OptiPlex 3020, 7020 and 9020 mini-tower desktops
This new power supply matches the 290 watt rating required by Dell OptiPlex 3020, 7020 and 9020 mini-tower chassis. It accepts a wide 100-240 volt input range at 5.4 amps and 50-60 hertz, so it works on standard mains worldwide. The unit replaces Dell part numbers WHN49, XFXKX and P2W4R directly.
It suits anyone restoring or repairing those specific mini-tower models when the original supply has failed or is missing. Builders working with small-form-factor, micro-tower or any non-MT OptiPlex should look elsewhere because the connector layout and mounting differ. Systems that demand more than 290 watts of continuous power also need a higher-rated unit.
The single specification that decides fitment is the 290 watt maximum power rating combined with the listed model numbers L290EM-00, D290EM-00 and F290EM-00. If the target computer requires exactly that wattage and carries one of those model labels, this supply is the correct match.
Measured against everything we stock in Server & Hot-Plug PSUs, at today’s prices. Recalculated every night.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Yes, the L290EM-00 is built for OptiPlex 3020, 7020 and 9020 MT mini-tower chassis, so it matches the mounting points and depth of those models.
Disconnect the mains cord, press the power button to drain residual charge, remove the four chassis screws, slide the old unit out, insert the replacement until the latch clicks, refit the screws, then reconnect the 24-pin and 4-pin CPU cables before restoring power.
Expect the internal fan to run continuously at 50-60 Hz input; if bearing noise appears or the 290 W output becomes unstable under load, replace the entire power supply rather than attempting a fan-only repair.
More in Server & Hot-Plug PSUs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?