We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey 44-pin DB44 male-to-female extension cable, 1.5M length

WMtec

WMtec DB44 3-row 44-pin male to female extension cable 1.5M

SKU CH-GPD8-CQZXT

A 1.5 m pure copper DB44 male-to-female extension cable with 44 pins in three rows for CNC programmer signals

  • Pure copper conductors ensure reliable signal transmission
  • Male-to-female 44-pin layout extends CNC programmer connections
  • 3-row DB44 design matches legacy industrial interfaces
  • 5-metre length provides flexible routing in control cabinets

DB44 extension cable for CNC programming

This 44-pin male to female extension cable uses pure copper conductors to carry programmer signals between equipment. The 1.5 m length suits bench or cabinet layouts where the controller and machine interface cannot sit side by side. It is built for industrial wiring tasks that demand a straight-through DB44 connection.

Shielded copper construction limits interference

Pure copper cores and a shielded jacket keep data lines clean in electrically noisy workshops. The cable draws no power of its own and adds negligible resistance to the signal path. Heat and audible noise are absent because the assembly is entirely passive. Builders who need a longer reach or a different pin count will need another solution.

How it compares

Measured against everything we stock in Fiber Optic Patch Cables, at today’s prices. Recalculated every night.

Price $10.99
Cheaper than about 90% of the 812 comparable items (median $29.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the 44-pin DB44 male end to my CNC programmer without bending pins?

Align the three-row 44-pin male connector with the female port, press straight in until the metal shell seats fully, and avoid angling the plug which can bend the dense pin array.

Will the pure copper conductors in this 1.5M extension need periodic re-termination?

The solid pure copper cores are crimped at the factory; under normal CNC signalling use they do not require re-termination unless the cable is repeatedly flexed at the connector strain relief.

More in Fiber Optic Patch Cables

Similar items