YesBes 116in cord hider kit 8pcs small W0.59in H0.4in self-adhesive

Small-profile cord hider kit

This 116-inch cord hider kit contains eight self-adhesive channels sized W0.59in by H0.4in. It is designed for home and office users who need to conceal one or two low-voltage wires along walls or furniture without drilling. The contemporary black finish suits modern decor while the UL94 V-0 rated plastic adds a flame-retardant safety layer. Supplied couplings, L-elbows and a T-fitting allow straightforward routing around corners and branches.

Adhesive-mounted raceway for tool-free fitting

Each 14.5-inch section bonds directly to smooth surfaces using the pre-applied tape, so no screws or wall anchors are required. The kit frees up visible floor and skirting space by lifting cables into a paintable channel that blends with the wall once coated. Installers must avoid textured walls because the adhesive will not hold securely on uneven plaster or brick. Cutting to length is done with ordinary scissors or a saw before the channel is pressed into place.

Capacity for one to two thin cords

The internal cross-section of .59in wide by .4in high comfortably fits a pair of typical charging or AV leads, but cannot accommodate thicker mains cables or bundles exceeding that diameter. At 116 inches the kit covers a standard TV-to-outlet run, yet falls short for whole-room perimeter routing where 315-inch or 630-inch kits would be needed. The material weighs .303 kilograms in total, keeping load on the adhesive minimal while maintaining the V-0 flame rating throughout.