We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Single tungsten steel end mill with two straight flutes, 6 mm shank and 17 mm cutting length, silver metal finish

YINGHUA

YINGHUA 1piece Two Flutes Straight Slot End Milling Cutter 6X6X17X50

SKU CH-7RX4-F1C7N

Two-flute carbide end mill cuts wood, acrylic, PVC and similar materials on CNC routers

  • Product typeRight-Angle Drills
  • Two-flute design clears chips efficiently for smooth cuts
  • Tungsten steel construction resists wear during extended milling
  • 17 mm cutting length suits detailed engraving work
  • Cuts acrylic, PVC, nylon, resin, wood and plywood
  • Right-angle drill compatibility simplifies tool changes

Two-flute end mill for CNC woodwork

This two-flute straight-slot end mill is made from tungsten steel and suits CNC engraving and cutting tasks. It handles acrylic, PVC, nylon, resin, wood and plywood with a precise cutting action.

Replaces worn carbide cutters in routing setups

Swap it in when an existing cutter dulls or chips and edge quality drops on fine detail work. The jump is worth it if the current tool leaves tear-out on plywood or melts acrylic instead of shearing it cleanly.

Shank fits standard collets for quick change

Insert the shank into a matching collet, tighten to the machine’s rated torque and verify run-out before cutting. Common issues include using the wrong collet size, exceeding recommended feed rates or cutting hazardous materials the tool is not rated for.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $20.99
Cheaper than about 81% of the 2,412 comparable items (median $81.99).

Specifications

Product
Product typeRight-Angle Drills

Questions about this item

What shank diameter does the 6X6X17X50 end mill need for the collet?

The cutter has a 6 mm shank, so it fits a standard 6 mm ER collet or 6 mm shrink-fit holder used on most CNC routers.

How do you install the carbide end mill without snapping the flutes?

Clean the collet and shank, insert the tool until the 17 mm flute length clears the collet face, then torque the collet nut to the machine maker’s spec — over-tightening cracks the carbide.

When should the tungsten-steel cutter be replaced during wood and acrylic work?

Replace it when the two flutes show visible rounding, chipping, or when cut quality drops and spindle load rises — typically after many hours in abrasive materials.

More in Power Drills, Drivers & Cutting Bits

Similar items