CableDeconn Mini SAS SFF-8087 to 4 SATA 90° cable .5m
Connects a 36-pin SFF-8087 port to four right-angle SATA drives at 6 GB/s over 0.5 m
- Connection typeUSB C to USB C
- 6 GB/s bandwidth supports fast SAS and SATA storage transfers
- 90-degree SATA connectors ease routing in tight drive bays
- 36-pin SFF-8087 plug fans out to four 7-pin SATA ports
- 5 m length keeps cable runs short and tidy
- Tinned-copper drain wire and 30 AWG conductors reduce signal loss
Mini SAS SFF-8087 fan-out cable
This cable connects a single 36-pin Mini SAS SFF-8087 port to four right-angle 7-pin SATA drives. It suits builders adding multiple hard disks or SSDs to a RAID controller or HBA inside a server or workstation chassis. The 0.5 metre length keeps routing tidy in dense drive cages.
Replaces loose SATA cables from controller
Use this fan-out when a controller provides only Mini SAS ports and you need to attach four SATA devices directly. The jump is worth it when cable clutter blocks airflow or when the backplane lacks native SATA connectors. Each leg ends in a 90-degree plug for tight drive bays.
Simple push-on installation
Push the Mini SAS end into the controller until it clicks, then seat each right-angle SATA connector onto the drive ports. The 30 AWG tinned copper drain wire handles grounding. What usually goes wrong is forcing a connector upside-down or not fully seating the latch, which breaks the 6GB/s link.
How it compares
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
- Price $15.99
- Pricier than about 55% of the 15,227 comparable items (median $14.99).
Specifications
| Ports & slots | |
|---|---|
| Connection type | USB C to USB C |
Questions about this item
What clearance does the 90-degree SATA connector need?
The right-angle 7-pin SATA ends require enough space behind the drive for the 90-degree bend; measure from the drive edge to the chassis wall before routing.
Which end plugs in first during installation?
Seat the 36-pin SFF-8087 mini-SAS connector into the controller or backplane first, then attach each 7-pin SATA plug to the target drives.
When should the cable be replaced?
Replace if the tinned-copper drain wire or 30 AWG conductors show damage, or if 6 Gb/s bandwidth errors appear on connected drives.
More in USB Cords & Extension Cables
Similar items
STARTECH UUSBHAUB6LA USB 2.0 A to Left Angle Micro USB B Cable
- USB A to Micro USB
- USB 2.0
ESTONE PQ001 USB4 Gen 3x2 Cable 5 ft Copper 240W 40Gbps 8K@60Hz
- USB C to USB C
- USB4
STARTECH USB3SEXT1M USB 3.0 extension cable 3.28 ft
- USB A to USB A
- Data Transfer Cable
ESTONE TJ-A323 USB4 cable 6.6ft 40Gbps 100W 8K@60Hz
- USB C to USB C
- USB4





