Cables To Go 04148 Cat6 network ethernet cable 1 ft red

One-Foot Cat6 Patch Cable for Tight Rack Spots

This 0.30 m red Cat6 patch cable connects two RJ45 ports in dense patch panels or behind wall plates where longer cables would bunch up. It meets TIA/EIA Cat6 specifications for gigabit Ethernet and bandwidth-intensive voice, data or video distribution. The non-booted, unshielded plugs insert and release easily in crowded ports. Builders who need longer runs or shielded links for noisy environments should choose a different length or construction.

Bonded-Pair Construction Keeps Signal Clean

Each twisted pair is bonded to preserve twist spacing right up to the termination point, reducing impedance variation and structural return loss. High-quality copper conductors minimise near-end crosstalk so the link stays error-free at full gigabit rates. The 1 ft length leaves no slack to coil, but it cannot span between separate racks or floor-standing equipment.

Passive Copper Runs Cool

The cable carries only signalling current, so it generates no measurable heat and adds no acoustic noise to the install. No external power supply or active electronics are involved, making it suitable for enclosed cabinets with restricted airflow. Installers who require PoE power delivery over the same run must verify the connected equipment supports the relevant standard.