Cables To Go 43171 35ft Cat6a network ethernet cable

35 ft Cat6a HDBaseT Cable

This 35 ft Cat6a patch cable uses RJ-45 male connectors on both ends and carries a blue jacket. It is built for installers who need a plenum-rated run that meets HDBaseT Class A and B certification and ANSI/TIA 568 C.2 channel requirements. The discontinuous shielding design removes the need for separate grounding while supporting 10 Gigabit data transmission.

Suits PoE and AV runs; not for non-plenum installs

The cable handles Power over Ethernet types 1 through 4 per IEEE 802.3 bt draft D1.2, making it a fit for conference-room extenders, digital signage and PoE devices that draw higher current. Buyers who need a riser or general-purpose jacket instead of CMP plenum rating should look at a different cable type. The snagless boot helps in dense patch panels but adds no benefit for loose desktop patching.

10 Gbps headroom with 0.265 in diameter

At the nominal 0.265 in diameter the cable fits tight pathways and achieves a smaller bend radius than typical Cat6a constructions, so density is the strong point. It comfortably carries 10 Gbps over the full 35 ft length and supports PoE up to type 4 current levels. Runs longer than the tested channel length or installations that require continuous foil-and-braid grounding will exceed the design envelope.