Cleer Enduro 100 ENDURO1BTNVYUS Navy 40mm Ironless Driver 100h Bluetooth 5.0 headphone
- 40 mm
- Headset
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Li-polymer replacement battery delivering 3.7 V and 610 mAh for JBL E45BT, E55BT and Everest Elite 300 headphones
This lithium-polymer cell restores power to JBL E45BT, E55BT and Everest Elite 300 headsets. It matches the original GSP753030 part and fits the factory battery compartment without modification. The 3.7 V 610 mAh capacity delivers the same runtime as the stock unit. Buyers who need a different voltage or connector should look elsewhere.
The 2.26 Wh rating supports continuous playback at typical listening levels without voltage sag. Li-polymer chemistry maintains stable output through the full discharge curve rather than fading quickly near the end. The slim 31.00 x 29.80 x 6.80 mm profile ensures consistent thermal contact with the headset chassis. Users expecting days of standby time from a single charge will not find that here.
This single figure determines whether the cell physically fits and electrically matches the original design. A higher-capacity pack would exceed the 6.80 mm thickness limit; a lower one would reduce playtime below the factory spec. The 3.7 V nominal voltage is fixed by the headset charging circuit. Select this part only when the original GSP753030 is specified.
Measured against everything we stock in Earbuds & Over-Ear Headphones, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Cameron Sino |
| Model name | DS-CS-JBE300SL |
| Product type | HeadPhone Battery |
The 3.7 V 610 mAh Li-Polymer cell runs at low voltage and typically stays cool during normal headphone operation.
You need a small Phillips screwdriver, a plastic pry tool and the original connector that matches the GSP753030 pinout.
Yes, the dimensions match the original GSP753030 cell so it sits in the existing compartment without trimming.
More in Earbuds & Over-Ear Headphones
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?