Nippon Labs USB-LI-6-SL 6 ft MFI lightning cable
- Apple
- Aluminum MFI Lightn…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Three 10 ft MFi certified Lightning cables rated for 2.4 A charging and 20000+ bend cycles
This three-pack supplies three ten-foot USB-A to Lightning cables for charging and syncing iPhone and iPad models from the 5 series through the 14 series. Each cable carries MFi certification so devices recognise the accessory without warning messages. The extra length lets you reach a wall outlet from a sofa, desk or rear car seat. Buyers who need a single shorter cable or a USB-C connector should look elsewhere.
The copper core and integrated smart chip manage current up to 2.4 A while providing overcharge, stable-current and battery protection. In normal use the cable stays cool to the touch and adds no audible noise to the charging setup. Power draw is limited by the connected charger and device rather than the cable itself. No active cooling or fan is involved.
The reinforced stress points are rated for more than twenty thousand bends, replacing lighter cords that fray near the connector after months of daily flexing. The jump is worth it when you regularly charge at a distance and want a cable that survives repeated coiling and uncoiling. If your charging stations are all within a metre of the outlet the extra length and bend rating may be unnecessary.
Measured against everything we stock in Lightning Charge & Sync Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Lightning Cable |
Plug the USB‑A end into a charger or port, then insert the Lightning connector until it clicks; the step people skip is pushing it in fully so the MFi chip registers and enables 2.4A charging.
Each cable is rated for 20000+ bends; replace a cord when the strain relief cracks or charging becomes intermittent.
The 2.4A current ceiling is the first bottleneck; the cable cannot deliver more power even if the charger supports higher output.
More in Lightning Charge & Sync Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?