We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical carbide end mill, grey uncoated finish, .625 inch diameter

Cleveland

Cleveland C60500 Garden Statue

SKU CH-FF37-AZ7W9

A carbide square end mill with a .625 inch diameter and 1.625 inch length of cut for aluminum milling

  • Product typeCutting Tools
  • .625 in milling diameter for precise aluminium cuts
  • 625 in length of cut handles deep pockets in one pass
  • Solid carbide construction resists wear in high-speed milling
  • Uncoated surface prevents built-up edge on non-ferrous alloys
  • Straight shank design fits standard 5/8 in tool holders

Cleveland C60500 End Mill

The Cleveland C60500 is a two-flute carbide square end mill designed for aluminium milling. It suits machinists and fabricators who need a single-end tool for general-purpose slotting and profiling in non-ferrous materials.

Uncoated Carbide Construction

The uncoated carbide substrate provides sharp edge retention in aluminium without the risk of coating delamination. A straight shank and non-coolant-through body keep the tool compatible with standard collet holders and conventional flood-coolant setups.

Verify Shank And Length Of Cut

Confirm that your holder accepts a 5/8 in shank diameter before ordering. Ensure the 1.625 in length of cut and 4 in overall length suit your machine’s work envelope and required reach.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $103.99
Pricier than about 82% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameCLEVELAND
Product typeCutting Tools

Questions about this item

When should the .625 in carbide end mill be replaced?

Replace the .625 in carbide end mill when cutting edges show visible chipping, flank wear becomes noticeable, or surface finish on aluminium deteriorates beyond acceptable limits.

What limits continuous cutting with the 1.625 in length of cut?

Heat buildup in the uncoated carbide and chip evacuation in the 1.625 in flute length become limiting factors during prolonged aluminium milling.

How much heat and noise does the 60500 end mill produce during extended runs?

The uncoated carbide generates moderate heat in aluminium; noise stays low with proper clamping and coolant, but increases if chip packing occurs in deep slots.

More in Yard Ornaments & Garden Statues

Similar items