Pioneer TS-G1620F 6.5" 300W 2-Way Coaxial Car Speaker
- 6.5 in (16.5 cm)
- Coaxial
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Modular 1-inch super bullet tweeter with flush, angle and flat mounting options, 200 W peak and 50 W AES power handling, and 102 dB sensitivity
The DS18 PROTSQ3N1 is a 1-inch compression tweeter built for car-audio systems that demand high output from a compact driver. It uses an aluminium CCA voice coil and a neodymium magnet structure to deliver a peak power handling of 200 watts and an AES rating of 50 watts. A sensitivity of 102 dB means loud volume is reached with modest amplifier power.
This tweeter suits enthusiasts who want a single driver that can be flush-mounted, angle-mounted or surface-mounted using the included hardware. The three configurations also change the visual profile, letting installers match different interior styles. Buyers who need a dedicated midrange driver or a component set with a separate crossover network should look elsewhere.
The 4-ohm nominal impedance works with most car amplifiers and passive crossovers without special wiring. High sensitivity frees up amplifier headroom, so a smaller amp can drive the system to satisfying levels. The compact one-inch format fits tight dashboard or pillar locations where larger compression drivers cannot.
Measured against everything we stock in Car Stereo Speakers, at today’s prices. Recalculated every night.
No published specifications for this item yet.
The tweeter handles 200 W peak and 50 W AES; choose an amp rated near 50 W RMS per channel at 4 ohms to stay within the AES figure.
Yes, the 4-ohm impedance matches typical factory speakers, so it presents the same load to the amp when wired in parallel.
Play a test tone at a known voltage; the output should measure around 102 dB at 1 metre if the tweeter is working to spec.
More in Car Stereo Speakers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?