Enfain RJ45 male to female extension cable 90° down angle 1.5 m 28AWG
A 1.5 m RJ45 male-to-female extension cable with a 90° down-angle connector and screw-panel mount for secure installation
- Overall length1.5 m
Style Down Angle
- Down Angle$13.99
- Up Angle$13.99
- 5 m reach extends a network link without moving equipment
- 90° down angle routes the cable tight against a panel or chassis
- 28 AWG copper cores with foil shield carry the signal through the extension
- Screw-mount flange secures the female port to an industrial case or commercial computer
- Male-to-female design converts a fixed jack into a flexible connection point
Enfain RJ45 90° Down Angle Extension
This 1.5 m cable adds reach to an existing Ethernet run with a male-to-female layout. The fixed 90° down angle routes the jack away from tight panels or crowded rear I/O. A screw-mount flange secures the female end to a chassis or wall plate. Eight-core 28AWG conductors with aluminium foil shielding carry the signal.
Replacing a straight-through coupler
Use this when a straight connector blocks adjacent ports or presses against a side panel. The right-angle exit clears the obstruction without stressing the jack. It is worth the swap when the current cable cannot be rerouted or when a panel-mount female port is needed for a clean install.
Sustained signal integrity over the full length
The 28AWG copper cores and continuous foil shield maintain category performance across the 1.5 m run. The moulded strain relief and screw flange prevent micro-movement that degrades contact over time. The protective film ships intact and is removed before termination.
How it compares
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
- Price $13.99
- Cheaper than about 55% of the 9,945 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Size & build | |
|---|---|
| Overall length | 1.5 m |
Other versions of this model
1 more in the same range
Questions about this item
What panel cut-out size do the screw-mount ears on this 1.5 m Enfain cable need?
The screw-mount ears fit a standard RJ45 panel cut-out; use the two mounting holes on the female jack to secure it to your chassis or wall plate.
Which side of the 90° down-angle plug goes in first when routing the cable behind a rack?
Insert the straight female jack into the panel or device, then route the angled male plug downward so the 1.5 m cable runs parallel to the mounting surface.
How often should the 28AWG copper conductors and foil shield be inspected in an industrial cabinet?
Check the jacket and foil shield annually for abrasion or kinks; replace the cable if the conductors are exposed or the shield continuity is lost.
More in Ethernet & LAN Cables
Similar items
Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
Nippon Labs 60CAT6A-2YW Cat6A UTP network ethernet cable 2 ft yellow 24AWG
- 6A
- RJ45
Nippon Labs 60CAT6A-6WT Cat6A network ethernet cable 6 ft white 24 AWG
- 6A
- RJ45
Nippon Labs 60CAT6A-10WT network ethernet cable Cat6A 10 ft 24AWG RJ45 White
- 6A
- RJ45
Cables To Go 31360 Cat6 network ethernet cable 75 ft Gray
- RJ45
- RJ45
Intellinet Cat6 U/UTP Slim Ethernet Cable 10 ft Green 10-Pack 30 AWG
- RJ45
- RJ45






