Ficer Technology Co., Ltd 10G SFP+ AOC Fibre Optic Cable 10m

10G SFP+ Active Optical Cable

This 10 metre active optical cable uses SFP+ connectors at both ends to deliver 10 Gbps links between switches, routers, servers or network cards. It is built for data-centre and storage-area-network environments that need longer reach than passive copper twinax allows. The cable suits installers who want a single factory-coded assembly instead of separate transceivers and patch cords.

Sustained-load signal integrity

The 850 nm VCSEL transmitter and PIN receiver maintain low bit-error rates over the full 10 metre OM3 multimode run without the signal degradation that copper cables exhibit at distance. Power draw stays below 1.0 W from a single 3.3 V supply, so thermal load on dense switch panels remains minimal during continuous operation. Hot-pluggable SFP+ housings let technicians add or replace links without powering down the chassis.

IEEE 802.3ae 10GBASE-SR compliance

This cable meets the 10GBASE-SR standard, so it will interoperate with any SFP+ port that follows the same specification. It also satisfies SFF-8431 and SFF-8472 management-interface requirements, enabling diagnostic monitoring on compliant hosts. Buyers who need InfiniBand SDR, DDR, QDR or FDR-10 rates up to 11.2 Gbps should verify their equipment supports those protocols over this cable type.