Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A new 150W UHP projector lamp module with 2,000-hour rated life, supplied as a complete bulb-and-housing assembly for direct installation
This 150W lamp module fits the Hitachi CP-S850 projector and arrives with the bulb already seated in its housing. The DT00236 part number matches the original equipment specification for a direct swap. Installation requires no separate bulb handling or alignment.
Each unit is manufactured to ISO 9001 quality standards and tested for beam performance, ignition voltage, and run-time before shipping. The pre-assembled housing eliminates the risk of damaging a bare bulb during replacement. Connectors match the factory layout so the projector recognises the lamp immediately.
The UHP bulb delivers a rated 2000 hours of operation, returning the projector to its original light output. This lamp replaces a dim or expired module in classroom, meeting-room, or home-cinema setups. It is not suited for users who need a higher-wattage or longer-life alternative than the 150W, 2000-hour specification.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 150 W |
The DT00236 module is built for the Hitachi CP-S850 projector and ships as a complete housing with the 150W UHP bulb already installed.
The housing matches the original CP-S850 form factor, so it seats in the existing lamp cage and locks with the projector's native screw tabs.
Power off and cool the projector, open the lamp door, undo the retaining screws, swap the entire housing, re-tighten the screws, close the door, then reset the lamp-hour counter in the menu — skipping the reset is the common mistake.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?