Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A ready-to-install 150 W lamp module rated for 2,000 hours of projector use
This 150W UHP lamp module is built for the Hitachi CP-X938WB projector. It ships as a complete housing and bulb assembly so the unit slots in without extra steps. Rated life is 2,000 hours under normal use. The part corresponds to manufacturer reference DT00236.
It fits users who want a ready-to-install module that matches the original 150W specification. Buyers who need a different wattage or a bare bulb without housing should look elsewhere. The lamp is produced to ISO9001 quality checks for ignition, voltage and run-time consistency.
The single figure that determines fit is the 150W power rating paired with the CP-X938WB model designation. If your projector calls for a different wattage or a different lamp code this module will not operate correctly. Verify the 150W requirement before ordering.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 150 W |
The DT00236 module is a fully assembled 150W bulb and housing designed to match the CP-X938WB projector's lamp compartment and connector.
Power off and cool the projector, remove the lamp cover, release the securing screws, slide the DT00236 module in until the connector seats firmly, retighten screws, replace cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.
Replace the lamp once the projector indicates end of life or after approximately 2000 hours of use; install a new DT00236 module following the same installation steps and reset the lamp timer again.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?