We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green spool of 0.6 mm lead-free solder wire, 100 g

KEHIPI

KEHIPI 100g 0.6mm Solder Wire Sn99.3 Cu0.7 Green

SKU CH-Y2QD-NHM9M

Lead-free solder wire, 0.6 mm diameter and 100 g, with 2 % flux for electronics work

  • Color and finishGreen
  • Lead-free alloy with Sn 99.3 Cu 0.7 composition
  • 6 mm diameter enables precise joints on small pads
  • 100 g spool provides ample length for multiple projects
  • Melting range 215 °C – 220 °C suits standard iron tips
  • 2 % flux core promotes clean wetting without extra paste

Lead-free 0.6 mm solder wire

KEHIPI supplies a 100 g spool of Sn99.3 Cu0.7 alloy wire with 2 % flux core, diameter 0.6 mm, formulated for electronics assembly and repair work where lead-free compliance is required.

Melting range and flux behaviour

The alloy melts between 215 °C and 220 °C with a recommended working point of 217 °C, and the 2 % flux content promotes smooth flow and fast wetting without excessive smoke or splatter during normal hand-soldering.

Replaces leaded 60/40 wire for RoHS jobs

This spool substitutes traditional Sn60 Pb40 wire in applications that must avoid lead; the jump is worthwhile when regulations or customer specifications demand a lead-free joint and the slightly higher melting range is acceptable for the components being soldered.

How it compares

Measured against everything we stock in Soldering Irons & Stations, at today’s prices. Recalculated every night.

Price $17.99
Cheaper than about 66% of the 802 comparable items (median $25.99).

Specifications

Product
Color and finishGreen

Questions about this item

How do I feed the 0.6 mm wire into a soldering iron tip without it jamming?

Use a tip with a 0.6 mm or wider bore, heat to 217 °C, then push the wire straight in so the 2 % flux core melts evenly; bending the tip or feeding at an angle causes the thin wire to buckle.

When will the 100 g spool run out and need replacing?

A 100 g roll of 0.6 mm Sn99.3 Cu0.7 wire yields roughly 2 000 typical 2 mm joints; heavy daily use can empty it in a few weeks, while occasional repair work may last months.

What happens if I hold the iron above 220 °C for a long session?

The alloy melts at 215–220 °C; sustained temperatures above 220 °C accelerate flux burn-off and tip oxidation, so the joint quality degrades before the wire itself fails.

More in Soldering Irons & Stations

Similar items