Logico P6EU15BK-10 Cat6 UTP Ethernet Cable 15 ft Black 10 Pack

Ten-pack Cat6 UTP patch cables

This ten-pack supplies fifteen-foot Cat6 unshielded twisted-pair cables with RJ-45 ends for wired Ethernet runs. Each cable uses 24 AWG stranded conductors rated to 550 MHz and follows the T-568B wiring standard. Gold-plated contacts at fifty microns resist corrosion on every plug. The black jacket helps identify links in a busy rack or desk setup.

Snag-free boots and moulded strain relief

Moulded strain relief stops the connector from bending at a sharp angle when the cable is routed around corners. A snag-free boot covers the release tab so it will not catch on neighbouring cables during pulls. Stranded conductors make the cable flexible enough for tight bends behind furniture or patch panels. No special tools are required beyond a standard RJ-45 crimp if you ever re-terminate.

Verify port speed and cable length before ordering

Confirm that your switch, router or NIC supports Gigabit or faster speeds to use the Cat6 rating. Measure each run so the fifteen-foot length reaches without excess slack or tension. Ensure the equipment uses standard RJ-45 sockets rather than proprietary connectors. The unshielded design suits typical indoor environments without heavy electromagnetic interference.