Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two RP-SMA male-to-female cables extend Wi-Fi antennas 33 ft for optimal placement on 802.11 a/b/g/n networks
This two-pack supplies two RP-SMA male-to-female extension cables for Wi-Fi antennas. Each cable measures 33 ft, letting you relocate the antenna away from the router or network card. The pair suits home or small-office wireless LAN gear that uses reverse-polarity SMA connectors.
The cables are described as brand new and high quality with RP-SMA ends that match IEEE 802.11a, 802.11b, 802.11g and 802.11n wireless LAN equipment. Because they are RP-SMA and not standard SMA, they thread directly onto compatible router, bridge, network-card or IP-camera ports without adapters. The long run lets you route the antenna around walls or through ceilings for clearer line of sight.
These extensions replace short factory pigtails or missing antenna leads that keep the antenna stuck at the device chassis. The improvement is worthwhile when the stock cable is too short to reach a window, mast or high shelf where signal strength is better. Buyers who need SMA rather than RP-SMA connectors, or who require cables for television or other non-Wi-Fi RF applications, should look elsewhere.
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | LORDWORLD |
The cable is compliant with IEEE 802.11a, 802.11b, 802.11g and 802.11n wireless LANs.
One end needs an RP-SMA female port and the other an RP-SMA male port; it will not mate with standard SMA connectors.
More in Ethernet & LAN Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?