We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 4.0 mm 2-flute necked end mill with cylindrical shank

M.A. Ford

M.A. Ford 13515700N3 End Mill 4.0mm 2 Flute Necked

SKU CH-WXCM-NFRY9

TuffCut Al 2-flute necked end mill, 4.0 mm diameter, designed for aluminium machining

  • Product typeCutting Tools
  • 0 mm necked end mill reaches deep cavities
  • Two-flute geometry clears chips efficiently in aluminium
  • M.A. Ford TuffCut AL coating extends tool life
  • New cutting tool ready for immediate workshop use
  • California Proposition 65 chemical warning applies to this item

Cutting Tool for Aluminium

The M.A. Ford 13515700N3 is a two-flute necked end mill designed for aluminium machining. Its 4.0 mm cutting diameter suits precision milling tasks in workshop environments. The tool targets machinists and fabricators who need reliable material removal in non-ferrous metals. This cutting tool arrives in new condition.

Necked Geometry and Coating

The necked shank provides extended reach for deeper cavities without interference. Two flutes allow efficient chip evacuation during high-speed aluminium cuts. The TuffCut Al designation indicates a geometry optimised for sticky alloys. California Proposition 65 warnings note chemicals linked to cancer and reproductive harm.

Workshop Thermal Behaviour

Aluminium machining generates heat that the two-flute design helps dissipate through large chip gullets. Proper coolant or mist reduces thermal load on the cutting edges. Power draw depends on spindle speed, feed rate and machine rigidity. Noise levels vary with the specific machining centre and workholding setup.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $20.99
Cheaper than about 74% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What shank diameter does the 4.0 mm necked end mill require for tool-holder fit?

The cutter has a 4.0 mm cutting diameter with a necked profile; the shank matches standard holders for that size so it fits directly into a 4.0 mm collet or shrink-fit chuck without adapters.

What clearance does the necked section provide for deep-pocket milling?

The reduced neck behind the 4.0 mm flutes gives extra reach so the tool clears vertical walls and fixture clamps during deep cavity work in aluminium.

How should the 2-flute TuffCut Al end mill be mounted to avoid run-out?

Clean the shank and collet faces, insert the tool until the shank seats fully, then tighten the collet nut to the holder’s specified torque while supporting the cutter to prevent eccentric loading.

More in Yard Ornaments & Garden Statues

Similar items