We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical silver end mill with two flutes and a necked shank, 4.0 mm diameter

M.A. Ford

M.A. Ford 13515703N3 Tuffcut Al End Mill 4.0Mm

SKU CH-893D-NBDYT

A necked two-flute end mill for aluminium, 4.0 mm diameter, suited to slotting and profiling

  • Product typeCutting Tools
  • 2-flute design clears chips efficiently in aluminium
  • necked shank reaches deep cavities without interference
  • 0 mm diameter suits precision milling tasks
  • Tuffcut Al geometry reduces built-up edge on soft metals
  • California Proposition 65 warning informs safe handling practices

Tuffcut Al 4.0 mm End Mill

This M.A. Ford 13515703N3 Tuffcut Al end mill is a 4.0 mm diameter cutting tool with a necked design and two flutes. It is intended for machinists and fabricators working on aluminium alloys and other non-ferrous materials where chip evacuation is critical.

Upgrade from standard flute tools

The necked profile and two-flute geometry replace conventional end mills when deeper reach or improved chip clearance in aluminium is required. The jump is worth it when standard tools rub on walls or pack flutes in soft, sticky alloys during profiling or slotting operations.

Limits of the necked two-flute design

The reduced core diameter at the neck limits rigidity compared to solid-shank tools, so heavy roughing cuts may deflect or chatter. The two-flute layout restricts feed rates in harder materials, and the cutting length confines the maximum depth of cut in a single pass.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $22.99
Cheaper than about 71% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What shank diameter does the 4.0 mm necked end mill need in the tool holder?

The cutter has a 4.0 mm cutting diameter and a necked 2-flute design; match the holder to the shank size shown on the tool shank.

How do you install the 13515703N3 end mill without causing run-out?

Clean the collet and shank, insert the tool to the recommended depth, and tighten the collet nut evenly with a torque wrench.

When should the Tuffcut Al 2-flute end mill be replaced?

Replace the cutter when flank wear reaches the manufacturer's limit or when surface finish on aluminium degrades noticeably.

More in Yard Ornaments & Garden Statues

Similar items