We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 12.0 mm two-flute end mill with necked shank

M.A. Ford

M.A. Ford Tuffcut Al 2 Flute End Mill Necked 12.0mm

SKU CH-2B94-A1AZC

A 12.0mm necked two-flute end mill designed for aluminium cutting applications

  • Product typeCutting Tools
  • Precision milling with 2-flute aluminium design
  • Neck geometry allows deeper cavity access
  • 0 mm diameter suits standard tooling
  • California Proposition 65 chemical warning applies
  • Brand-new condition from M.A. Ford

Tuffcut Al 2 Flute End Mill 12.0mm

This M.A. Ford cutting tool is a two-flute end mill with a necked design and a 12.0mm diameter. It is intended for machining operations that require aluminium-specific geometry. The product ships new directly from the manufacturer.

Upgrading from standard end mills

A necked profile provides additional reach for deep pockets or cavities where a standard flute length cannot clear. The two-flute design prioritises chip evacuation in non-ferrous materials. Buyers who need higher flute counts for finishing passes or different substrate coatings should evaluate other tooling options.

California Proposition 65 compliance

This item carries a Proposition 65 warning for chemicals known to the State of California to cause cancer and reproductive harm. Safe handling practices and appropriate personal protective equipment are required during use. Orders of $75 or more qualify for free shipping from the supplier.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $84.99
Pricier than about 78% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What collet or holder size fits the 12.0 mm shank of this end mill?

Use a 12.0 mm ER collet, shrink-fit holder or hydraulic chuck with a matching bore; the necked section requires clearance behind the collet face.

Which step do operators most often miss when setting up this necked cutter?

They forget to measure tool length after the neck, so the programmed Z-zero sits at the shank instead of the cutting edges.

When should this Tuffcut Al cutter be replaced in aluminium work?

Replace it once flank wear lands reach the wear-mark line or when built-up edge starts leaving a cloudy finish on the workpiece.

More in Yard Ornaments & Garden Statues

Similar items