Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Twelve one-foot black Cat6 patch cables with 550 MHz bandwidth, 24 AWG pure bare copper conductors, and slim FLEXboot snagless plugs for dense panels
This twelve-pack of Cat6 patch cables is built for installers wiring high-density patch panels and network cabinets. Each cable uses 24AWG stranded pure bare copper conductors and meets UL 444 and TIA-568-C.2 requirements for permanent installations. The one-foot length keeps cable management tidy in 12, 24, 48 and 96-port environments.
Passive copper cables generate no heat, produce no audible noise and draw no electrical power during operation. Signal integrity is maintained by 50µm gold-plated contacts that resist corrosion over long-term use. The thin FLEXboot design protects the RJ45 retaining clip while allowing easy release in crowded racks.
Rated for 550MHz bandwidth, these UTP cables support gigabit Ethernet transmission across the full one-foot run. The Category 6 specification and pure bare copper construction ensure compliance with fire and safety codes for in-wall and plenum-adjacent routing. Buyers needing shielded cable or longer individual runs should select a different product.
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Monoprice |
| Model name | 141812 |
| Product type | Networking Patch Cables |
| Product color | Black |
Depress the thin FLEXboot cover to release the clip, insert the RJ45 plug until it clicks, then route the 1 ft stranded UTP cable through the panel’s cable-management rings to avoid tension on the 24 AWG conductors.
Inspect the 50 µm gold-plated contacts periodically for dust or oxidation; if a clip breaks or a conductor fails continuity testing, replace that individual 1 ft patch cord rather than the whole pack.
The 24 AWG stranded pure bare copper conductors reach their insertion-loss ceiling before the 550 MHz bandwidth rating is exceeded, so keep total channel length within TIA-568-C.2 limits to avoid errors.
More in Ethernet & LAN Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?