myVolts E6B2-CWZ6C 38mm 200P/R transducer

38 mm incremental encoder for motion control

The myVolts E6B2-CWZ6C is a 38 mm diameter incremental encoder that delivers 200 pulses per revolution. It operates on a DC 5 to 26 V supply with open-collector output and provides A, B and Z phase signals. The stainless-steel spindle and alloy shell give mechanical stability in industrial environments.

Upgrade from lower-resolution or non-ASIC encoders

Replacing a basic encoder with this unit adds internal ASIC circuitry for stronger anti-interference performance and longer service life. The jump is worthwhile when the application needs reliable 200 P/R feedback, built-in load short-circuit protection and power-supply reverse-wiring protection. It also suits designs that require axial loads up to 30 N and thrust loads up to 20 N.

Limits of open-collector output at 26 V

The open-collector interface works with the stated DC 5 to 26 V range and the supplied 2 m cable, but signal integrity over longer runs depends on external pull-up resistors and cable capacitance. Differential or push-pull output modes are listed as available options, yet the standard wiring harness only guarantees the open-collector configuration. Buyers needing noise-immune transmission over extended distances must verify the chosen output mode matches their controller requirements.