NEMIX RAM 16GB (2x8GB) DDR5 5600 CL46 1.1V UDIMM memory upgrade for Supermicro X13SAE

Exact-fit DDR5 kit for Supermicro X13SAE

This 16GB kit contains two 8GB DDR5 5600 UDIMM modules built to the board's native PC5-44800 specification. The 1Rx8, non-ECC, unbuffered design matches the memory controller's expected rank structure, voltage and timing so the system recognises full capacity at rated speed without manual tuning. Major OEM chips from Samsung, Micron or Hynix are tested for stability at CL46 and 1.1V. The 288-pin form factor installs directly into the desktop DIMM slots the X13SAE provides.

Builders upgrading that specific motherboard

The kit suits anyone adding or replacing memory in a Supermicro X13SAE that requires DDR5 5600 unbuffered non-ECC UDIMMs. It will not work for systems that need ECC registered modules, SODIMM form factors, a different DDR generation, or a speed and voltage combination other than 5600 MT/s at 1.1V. Buyers whose boards demand higher capacities per slot, lower CAS latency, or registered DIMMs should look at other parts.

1Rx8 single-rank organisation

Each module uses a single-rank 1Rx8 layout, which is the exact density the X13SAE memory controller expects for reliable operation at DDR5 5600. A dual-rank or x4-based module would change the electrical loading and can prevent the board from training at the rated speed. Verifying the 1Rx8 rank structure against your motherboard manual is the single check that confirms this kit will post at full frequency.