NEMIX RAM MR44800-924K12 768GB (12x64GB) DDR5 5600MHz CL46 ECC Registered RDIMM memory upgrade

768GB DDR5 RDIMM kit for GIGABYTE MZ33-CP1

This 12-module kit delivers 768GB of DDR5 5600 memory in a 288-pin registered ECC RDIMM form factor. It is built to match the exact rank, voltage and timing requirements of the GIGABYTE MZ33-CP1 motherboard so the system recognises the full capacity at rated speed. Each module operates at 1.1V with CL46 latency and 2Rx4 organisation. The kit targets server deployments that need maximum registered DIMM capacity on this specific platform.

Registered ECC stability under full population

The registered architecture buffers address and command signals, reducing electrical load on the memory controller when all slots are occupied. This allows every DIMM to run at the rated 5600 MT/s without down-clocking due to signal integrity limits. On-die ECC corrects single-bit errors in real time, preventing silent data corruption during sustained workloads. The 1.1V operating voltage keeps power draw consistent across the fully populated configuration.

DDR5 5600 PC5-44800 interface limits

The DDR5 5600 standard caps the data rate at 5600 MT/s per pin, yielding a peak module bandwidth of PC5-44800. Registered DIMMs add one clock cycle of latency for buffering, which is reflected in the CL46 timing. Maximum capacity is constrained by the motherboard's memory controller and qualified vendor list; exceeding the validated 768GB per this kit requires board-level support not guaranteed by the memory specification alone. Systems needing higher density or faster speeds must verify controller and firmware capabilities separately.