Nippon Labs 60CAT6-100BL Cat6 network ethernet cable 100 ft Blue

100 ft Cat6 UTP patch cable

This 100 ft Cat6 unshielded twisted pair cable uses 24 AWG stranded bare copper conductors and RJ45 plugs with 50 micron gold-plated contacts. It is wired to the T568B standard and covered by a blue PVC jacket with snagless molded boots. The cable meets TIA/EIA-568-C.2 Category 6 requirements and carries UL and ETL verification plus RoHS compliance.

Check connector type and run length

Verify that both endpoints accept standard RJ45 connectors and that a 100 ft run fits the intended path without exceeding the 100 metre channel limit for Cat6. The stranded construction suits patching between devices, patch panels or wall plates rather than permanent in-wall installation. Ensure the snagless boots clear adjacent ports on dense switches or routers.

Passive cable — no thermal or power concerns

As a passive copper cable it generates no heat, draws no power and produces no audible noise during operation. The PVC jacket and snagless boots protect the conductors and locking tabs from physical damage during routine handling. Gold-plated contacts resist oxidation to maintain low-contact resistance over the cable’s service life.