Nippon Labs 60CAT6A-2WT Cat6A UTP network ethernet cable 2 ft White 24AWG

Nippon Labs Cat6A 2 ft patch cable

This 2 ft Cat6A UTP patch cable from Nippon Labs uses 24 AWG stranded pure copper conductors with RJ45 connectors on both ends. It is built to the T568B wiring standard and meets TIA/EIA requirements verified by UL and ETL, plus RoHS compliance. The white CM-rated PVC jacket covers four unshielded twisted pairs rated for a minimum frequency of 500 MHz. It supports 10Base-T, 100Base-T, 1000Base-T and 10,000Base-T Ethernet up to 100 metres (328 feet).

Boots and gold contacts

Each connector has a molded strain-relief boot and a snagless mold that protects the latch during repeated insertion and removal. Gold-plated contacts rated at 50 micron resist corrosion and maintain low resistance over the life of the cable. The booted design reduces cable stress at the plug, which helps preserve signal integrity in tight patch-panel or switch installations. The stranded construction keeps the short run flexible for routing around equipment.

Desktop and rack patching

The 2 ft length suits short connections between a wall jack and a PC, a switch and a server, or adjacent rack units where slack must be minimal. Installers who need shielded cable for high-EMI environments, longer runs beyond 100 metres, or outdoor-rated jackets should choose a different product. Buyers requiring plenum-rated (CMP) or riser-rated (CMR) fire classifications will also need an alternative cable type.