Nippon Labs 60CAT6A-50BK network ethernet cable Cat6A 50 ft 24 AWG UTP Black

Nippon Labs Cat6A 50 ft UTP cable

This 50-foot Cat6A UTP patch cable uses 24 AWG stranded pure copper conductors and RJ45 plugs with 50 micron gold-plated contacts. It is built for 10 Gigabit Ethernet links up to 100 metres and operates at a minimum frequency of 500 MHz. The CM-rated PVC jacket meets TIA/EIA standards verified by UL and ETL and is RoHS compliant. Wiring follows the T568B standard.

Before ordering check your port speed and run length

Verify that your router, switch or network card supports 10,000Base-T to use the full 10 Gigabit capability. Ensure the 50-foot length fits the planned cable route without exceeding the 100-metre channel limit for Cat6A. Confirm that the UTP construction suits your environment, as shielded cable may be preferred in high-interference areas.

Boots and gold contacts improve daily handling

Moulded boots protect the RJ45 latch from snapping during repeated insertions or tight routing. Gold-plated contacts resist oxidation for reliable signal integrity over time. The stranded conductor design adds flexibility for patch-panel and desk-side connections. No software or drivers are included or required.