Nippon Labs 60CAT8-25-24GY-10P network ethernet cable 25 ft Cat 8 40G 2GHz 24AWG 10 pack

Ten-pack Cat 8 patch cables for 40 Gbps runs

This ten-pack supplies 25 ft Cat 8 cables rated for 40 Gbps at 2 GHz. Each cable uses stranded 24 AWG pure copper conductors with individual foil shields and an overall braid shield. RJ45 plugs carry 50 µm gold-plated contacts and a snagless, strain-relieved boot. The PVC jacket is CM rated and the cords are fully backward compatible with earlier categories.

Push-tab RJ45 eases routing in tight racks

The soft flex push tab lets you lock or release the connector without fighting a stiff latch. Molded strain relief stops the boot from snagging on cable managers or sharp edges during pulls. Because each pair is foil wrapped and the four pairs share a braid, the bundle is thicker than unshielded patch cords, so allow extra room in dense patch panels. No special tools are needed beyond a standard RJ45 crimper if you ever re-terminate.

Verify port speed and switch uplink budget first

Confirm that your switch, router or NIC actually negotiates 25GBASE-T or 40GBASE-T; the cable will fall back to lower speeds if the hardware cannot drive 2 GHz. Check that the 25 ft length fits your rack layout without exceeding the channel limit for the target speed. Ensure the equipment side accepts standard RJ45 pinout and that shielded plugs fit the port spacing on your patch panel.