Nippon Labs 80C6U-420GY network ethernet cable Cat 6 UTP 23 AWG 1000 ft gray

Indoor CM-Rated Runs

Nippon Labs 80C6U-420GY is a Category 6 UTP bulk cable built for indoor installations. The 1000 ft pull box contains solid 23 AWG bare copper conductors with HDPE insulation and a PVC CM-rated jacket. ETL verification and RoHS compliance confirm the cable meets TIA 568 C.2 requirements for structured wiring.

Installers Wiring Walls, Not Patch Cords

This reel suits technicians pulling cable through studs, conduit or ceiling spaces where a CM rating is required. It is not made for outdoor burial, plenum air-handling areas or pre-terminated patch-cable assemblies. Buyers needing shielded pairs, higher fire ratings or shorter ready-made lengths should look at other cable types.

600 MHz Verified Bandwidth

The single figure that decides fit is the tested 600 MHz bandwidth, which supports Gigabit Ethernet, Fast Ethernet and 155 Mbps TP-PMD/CDDI signals. If the project specification calls for a different frequency rating or a higher category, this cable will not meet that requirement.