OPTOMA GT5000 projector lamp 260W P-VIP 3000 hrs

Optoma GT5000 replacement lamp

The Optoma GT5000 replacement lamp is a 260 W P-VIP module built for Optoma projectors that use the SP.72701GC01 assembly. It arrives as a complete bulb-and-housing unit so installers can swap the old module without handling a bare lamp. The unit is rated for 3,000 hours of operation and is manufactured to ISO9001 quality standards. Buyers who need a higher-wattage or longer-life module for a different projector model should look elsewhere.

Tool-free module swap

Installation consists of opening the projector lamp door, removing the securing screws, sliding out the old module and inserting the new one until it seats firmly. No wiring or alignment of a bare bulb is required because the lamp ships pre-assembled in its housing. The most common issue is forgetting to reset the projector's lamp-hour counter after the swap, which leaves the replacement warning active. Another frequent oversight is leaving the lamp-door safety switch unlatched, which prevents the projector from powering on.

Check projector model and lamp code

Verify that your projector lists the SP.72701GC01 lamp code in its service manual or on the existing module label before ordering. Confirm the projector accepts a 260 W P-VIP lamp; units designed for different wattages or lamp types will not operate correctly. Ensure the lamp compartment is free of dust and that the air filters are clean so the new module can reach its rated 3,000-hour life.