PYLE AUDIO PLMRCW3 marine electronic 9.18 x 4 x .5 white
- 4 in × 9.18 in × 0.…
- Accessories
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A pair of 4-inch waterproof marine tower speakers with blue LED lights and 12 V power cables
This pair of 4-inch Pyle tower speakers is built for boats, ATVs and Jeeps that need loud, weather-resistant audio. The waterproof, UV-resistant housings and titanium dome tweeters survive spray, salt and direct sunlight. They draw power from a 12-volt system and include blue LED illumination for night visibility.
The 4-ohm impedance and 12-volt input restrict usable amplifier power to what a typical vehicle electrical system can deliver. Frequency response spans 70 Hz to 20 kHz, so deep sub-bass below 70 Hz will not be reproduced. Continuous output above the rated 300 watt peak risks thermal compression in the compact enclosures.
Universal roll-bar clamps bolt directly to round tubing on boats, ATVs or Jeeps without drilling. The 12-volt power cables connect to the vehicle supply; reversing polarity will silence the speakers. LED wiring shares the same feed, so a loose connector kills both sound and light. Verify clamp diameter matches your roll bar before installation.
Measured against everything we stock in Boat Audio & Electronics, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Pyle |
| Product type | Marine Speaker |
| Audio & video | |
| Frequency range | 70 Hz - 20 kHz |
| Rated impedance | 4 Ohm |
| Power | |
| Supply voltage | 12 V |
| More details | |
| Driver design | 2-way Speaker |
The listing supplies a pair of two 4-inch tower speakers, so you get left and right channels for stereo coverage on a boat, ATV or Jeep roll bar.
The 300-watt peak power rating indicates maximum short-term output; continuous listening levels will be lower and depend on your 12-volt amplifier.
At 4 ohms the speakers draw more current than 8-ohm models, so pair them with a marine amplifier rated for 4-ohm loads to avoid overheating.
More in Boat Audio & Electronics
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?