We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three-jaw metal lathe chuck M14 65mm silver finish

Ruth's sister

Ruth's sister Internal Power Cable M14 65mm

SKU CH-06T5-F0C1A

Three-jaw manual lathe chuck with 65 mm capacity and M14 thread for metalworking and woodturning

  • 65 mm chuck diameter fits medium workpieces
  • M14 thread matches compatible lathe spindles
  • Three-jaw design centres round stock automatically
  • Manual operation gives direct clamping control

Internal Power Cable M14 65mm

This internal power cable uses an M14 connection and measures 65mm in length. It is built for system builders who need a short, precise power link inside a compact chassis. The cable suits tight routing paths where standard lengths create clutter or tension.

Thermals noise and power draw

As a passive cable assembly it generates no heat and produces no audible noise during operation. Power draw is limited to the transmission losses of the conductors carrying current to the connected component. No active cooling or fan control is required for this accessory.

How it compares

Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.

Price $33.99
Pricier than about 74% of the 7,839 comparable items (median $14.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the M14 thread on my lathe spindle without cross-threading?

Start the 14 mm thread by hand, turning slowly until it seats fully, then tighten with the chuck key; forcing it under power is the step most users get wrong.

Which parts of the 65 mm chuck will need replacement after extended use?

The three jaws and scroll plate wear first; keep a spare jaw set and re-grease the scroll monthly to maintain grip accuracy.

More in Internal PSU & Riser Cables

Similar items