We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
TB6600 stepper driver board with terminal connectors and heatsink

Ruth's sister

Ruth's sister TB6600 5A stepper driver nema 17 23 internal power cable

SKU CH-7Q99-VDMCQ

A 5 A TB6600 stepper driver for NEMA 17 and 23 CNC motors

  • Drives NEMA 17 and 23 motors reliably
  • 5 A peak current handles demanding CNC axes
  • TB6600 chipset ensures smooth two-phase hybrid operation
  • Single-axis design simplifies multi-axis machine wiring

TB6600 5A driver for NEMA 17 and 23 motors

This TB6600 stepper driver controls a single axis of a two-phase hybrid stepper motor. It suits CNC builders who need a 5 A module for NEMA 17 or NEMA 23 frames. The unit is an internal power cable component for custom motion-control assemblies.

Screw terminals simplify wiring but polarity must

Connections use screw terminals that accept stripped leads without special tools. The most common issue is reversing the motor phase wires, which causes the axis to vibrate instead of turning. Verify the coil pairs with a multimeter before applying power. Incorrect microstep jumper settings can also produce rough motion.

How it compares

Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.

Price $10.99
Cheaper than about 70% of the 7,839 comparable items (median $14.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the TB6600 5A stepper driver is operating correctly after wiring it to my NEMA 17 or 23 motor?

Power the driver, send step and direction pulses from your controller, and verify the motor shaft rotates smoothly in both directions without stalling or overheating.

What cables or connectors are included with the TB6600 5A driver, and what must I source separately for a NEMA 17 or 23 setup?

The unit is supplied as the driver board only; you will need to provide a suitable DC power supply, motor cables, and step/direction signal wires for your CNC controller.

More in Internal PSU & Riser Cables

Similar items