We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Siemens BQD250 two-pole breaker, grey plastic housing, toggle switch, bolt-on terminals

SIEMENS

SIEMENS BQD250 Miniature Circuit Breaker 50A 2 Pole 480V AC

SKU CH-1V8A-G8B8D

A 50 A, two-pole miniature circuit breaker rated for 480 V AC with a 14 kA interrupting rating, bolt-on mounting for Siemens P1 panelboards

  • 50 A protection backed by 14 kA interrupting rating at 480 V AC
  • Two-pole design covers single-phase circuits in Siemens P1 panelboards
  • Bolt-on mounting with lug terminals speeds panel installation
  • Compact 4.5 × 2 × 2.7 in frame fits 100 A BQD footprint
  • Rated for 125/250 V DC and 104 °F maximum operating temperature

50 A Two-Pole Breaker for P1 Panels

The Siemens BQD250 is a bolt-on miniature circuit breaker rated at 50 amps and 480 volts AC for single-phase loads. It fits Siemens P1 panelboards and load centers that accept the BQD frame size. The breaker uses a toggle actuator and lug terminals for standard wire connections. It is not suited for panels that require a different frame or mounting style.

Thermal and Electrical Performance

The device carries a maximum AIR rating of 14 kA at 480 volts AC, providing short-circuit protection within that limit. It is also rated for 125/250 volts DC where applicable. The maximum operating temperature is 104 degrees Fahrenheit, so the enclosure must stay within this ambient range. No active cooling or fan is included, and power draw is limited to the protected circuit itself.

Replaces Standard BQD Breakers in P1 Assemblies

This unit replaces an existing BQD-series breaker of the same ampere rating and pole count when the old device is worn, tripped irreversibly, or no longer meets inspection. The upgrade is worthwhile when a 50-amp, two-pole slot becomes available and the panel schedule calls for 480-volt AC single-phase protection. It does not add poles, increase frame size, or fit non-P1 panelboards.

How it compares

Measured against everything we stock in Breakers & Circuit Protection, at today’s prices. Recalculated every night.

Price $343.99
Pricier than about 89% of the 1,135 comparable items (median $54.99).

Specifications

Product
Brand nameSIEMENS

Questions about this item

How do I bolt the BQD250 into a Siemens P1 panelboard, and what step is often missed?

Align the bolt-on base with the panelboard bus, torque the mounting bolts to spec, then snap the lug terminals onto the conductors; the step often missed is verifying the 100 A frame fits the P1 rail before tightening.

What maintenance or replacement will the 50 A two-pole breaker need over time?

Periodically re-torque the lug connections, exercise the toggle actuator, and inspect for discoloration; replace the unit if it trips near 50 A without overload or after a 14 kA fault event.

What is the first limit reached when the breaker runs continuously at 480 V AC?

The 104 °F maximum operating temperature is the first sustained-use limit; exceeding it degrades calibration and can cause nuisance tripping before the 14 kA interrupting rating is tested.

More in Breakers & Circuit Protection

Similar items