TAURKENAM CP9972 cable protector 2-channel 39in 5000lb black yellow
Two-channel cable protector holds wires in 1.18 in by 1 in channels, supports 5000 lb per axle, and meets MUTCD, OSHA, RoHS and REACH standards
- Protects cables up to 5000 lbs per axle
- Two channels each 1.18 in wide by 1 in high
- Operates from -40 °F to 1310 °F
- Meets MUTCD, OSHA, RoHS and REACH standards
- Flip-open lid with black-yellow finish for high visibility
Two-channel cable protector for temporary routing
The TAURKENAM CP9972 provides two channels measuring 1.18 inches wide by 1 inch high to route cables across walkways or roadways. Black and yellow colouring and a flip-open lid make the ramp visible to drivers and pedestrians in low light. It suits indoor or outdoor sites where light traffic crosses temporary power or data runs.
Replaces loose covers
Loose mats or duct tape can shift under wheels and create trip hazards; this ramp stays in place and supports up to 5000 lbs per axle. The jump is worth it when vehicles up to that weight cross the cable path regularly and a compliant, reusable solution is required. It is not suited for heavy industrial traffic exceeding the rated axle load.
Flip-open lid eases cable placement on rubber base
The polyurethane lid hinges open so cables can be laid in the channels without threading, then snaps shut to protect them. Rubber base grips most hard surfaces but may slide on wet grass or polished stone. Ensure the operating temperature range of -40 °F to 1310 °F covers the site conditions before deployment.
How it compares
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
- Price $99.99
- Pricier than about 90% of the 3,875 comparable items (median $23.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What overall length and width does the CP9972 need on the floor?
The protector measures 39 inches long by 10 inches wide and sits 2 inches high, so allow that footprint plus clearance for the flip‑open lid.
How do you load cables into the two channels and what step is often missed?
Open the polyurethane lid, lay cables in each 1.18‑inch‑wide by 1‑inch‑high channel, then close the lid fully until it latches; the missed step is leaving the lid unlatched, which can let cables slip out.
When should the rubber base or polyurethane lid be replaced?
Replace the unit if the rubber base shows cracking, permanent deformation, or the lid hinge no longer locks securely, as these affect the 5000‑lb per‑axle rating.
More in AC Adapters & Power Bricks
Similar items
TAURKENAM 25 ft 12 Gauge SJTW Lighted Extension Cord power adapter
Ubiquiti Networks 210W AC Power Adapter for PoE Switches
- USB C Charger
- 9 V





