TeamProfitcom CPU 8 Pin Female to 8(4+4) Pin Male EPS-12V Extension Cable 25 Inches

Extension cable for ATX CPU power

This 25-inch extension connects a power supply 8-pin EPS-12V output to a motherboard 8(4+4)-pin EPS input using standard 18 AWG UL1007 wiring rated for 500 W. It is built for system builders who need extra reach when routing cables behind large motherboards or inside deep cases. The black sleeving keeps the installation tidy without adding bulk. The female end plugs into the PSU cable; the male end plugs into the board.

Replaces short factory EPS cables

Use this when the stock power-supply lead cannot span the distance to the CPU socket without tension or sharp bends. The 25-inch length adds meaningful slack for rear-routing channels or tall heatsink clearance. It is not a replacement for a missing PSU connector; the unit must already provide an 8-pin EPS output. Buyers whose PSU lacks that native connector cannot use this adapter.

Limited by EPS-12V current capacity

The 18 AWG conductors and UL1007 insulation set a 500 W ceiling, so the cable suits mainstream and mid-range platforms but not extreme overclocking loads that exceed that threshold. Voltage drop over 25 inches is minimal at typical currents, yet high-current builds should verify total system draw stays within the rating. The extension adds no active components, so signal integrity depends entirely on the host PSU and motherboard quality.