Tripp Lite N201-010-RD network ethernet cable Cat6 10 ft Red

Tripp Lite Cat6 10 ft Patch Cable

This Cat6 Ethernet cable connects two RJ45 ports over a 10 ft distance in a red jacket. It meets category 6 cabling standards and works with category 5e and category 5 applications. The snagless molded boots protect the connector tabs during installation and removal. High-quality copper conductors reduce impedance and structural return loss compared to standard 100MHz wire.

Sustained Signal Integrity Over Distance

The cable is built to maintain Gigabit throughput across the full 10 ft run without the degradation seen in lesser wires. Reduced impedance and structural return loss keep the signal stable under continuous load. The molded strain relief prevents conductor fatigue from repeated movement or vibration. Performance stays consistent rather than dropping after a short burst.

Category 6 Practical Limits

Category 6 cabling supports Gigabit speeds up to 100 metres, so a 10 ft patch cord uses only a small fraction of that range. The RJ45 connectors are rated for standard 8P8C ports and do not exceed the category's frequency ceiling. Buyers who need longer runs or higher-grade shielding should verify their infrastructure matches the cable category. This cable does not add capabilities beyond the Cat6 specification.