Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 25 ft Cat6a shielded cable with snagless RJ45 connectors for 10 GbE and PoE devices
The Tripp Lite N262-S25-BL is a 25 ft Category 6a patch cable built for 10 Gigabit Ethernet links. It uses RJ45 male connectors on both ends and a slim shielded design that fits tight racks and patch panels. The cable carries both data and Power over Ethernet for compatible devices. It suits installers who need a single run up to 25 ft.
This cable works well in dense data-centre rows where airflow matters and in ceiling or pole mounts where PoE devices sit far from mains power. It serves servers, switches, routers, printers, access points and VoIP phones that accept PoE. Buyers who need longer horizontal runs beyond 25 ft or who require unshielded cable for a specific installation should look elsewhere.
The fixed 25 ft length is the specification that decides fit. Measure the exact path between the two RJ45 ports including vertical managers and slack; if the distance exceeds 25 ft this cable will not reach.
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Size & build | |
|---|---|
| Overall length | 25 ft (7.62 m) |
| Shipping weight | 0.23 kg |
| Package size | 229 × 178 × 13 mm |
The slim-profile jacket is designed for high-density routing and improved airflow, making it easier to pull through tight cable-management channels and patch-panel openings.
Press each connector straight in until the latch clicks; the snagless boot protects the tab, but angling the plug during insertion can still snap it off.
Inspect the shield bonding and connector latches during any rack move or after 10 Gbps link errors; replace the cable if the jacket shows crush marks or the PoE device reports power faults.
More in Ethernet & LAN Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?