Tycon Power Systems TP-ESP-1000-POE24 24V PoE Surge Protector

Gigabit Surge Protector for 24V PoE Networks

The Tycon Power Systems TP-ESP-1000-POE24 is a Gigabit Ethernet surge protector built for 24V Power over Ethernet installations. It clamps transients on all eight CAT5 wires at 40V for PoE and 7.5V for data lines. A full metal housing provides EMI suppression while integral mounting feet and a separate ground wire simplify permanent installation indoors or inside a weatherproof outdoor enclosure. The unit complies with IEC 61643-21 and handles repeated surge events without degradation.

Suits Wireless APs and IP Cameras — Not 48V PoE

This protector fits wireless access points, IP phones, security cameras and industrial control systems that run on 24V PoE. Installers needing to safeguard longer outdoor cable runs from lightning-induced transients and grid fluctuations will benefit from the 5kA surge discharge rating. Buyers deploying 48V PoE equipment or requiring protection for fibre links should look at a different model because the clamping voltage and operating range are fixed at 24V.

40V Clamping on All Eight Pins Decides Fit

The single specification that determines compatibility is the 40V clamping voltage applied to every PoE pin at 24V operating voltage. If the connected device negotiates a higher PoE voltage the protector will not clamp correctly and the equipment remains exposed. Verify that the endpoint and switch both operate at 24V PoE before purchasing; no other voltage level is supported by this unit.