We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five small brass M6 nozzles with 0.2mm holes and stamped size markings

Unique-Bargains

Unique-Bargains 0.2mm M6 Brass Nozzle 5pcs

SKU CH-Z6QM-7PMQ8

Five brass M6 nozzles with a 0.2mm bore for 1.75mm filament on MK8 extruders

  • Product typePattern
  • Precise 0.2mm brass nozzle enables fine-detail prints
  • M6 thread fits MK8 1.75mm extruders directly
  • Stamped size marking simplifies nozzle identification
  • Clean threads and consistent bore reduce clog risk
  • Five-piece brass pack covers multiple material changes

Brass M6 Nozzle 0.2mm Pack

This pack contains five brass nozzles with an M6 thread, a 0.2mm orifice and a 1.75mm input diameter. Each nozzle measures 13mm long by 6mm wide and is stamped for easy identification. They are made for MK8 extruders that accept M6 threading.

Ideal for fine-detail printing

The 0.2mm bore suits users who need higher resolution on non-abrasive filaments such as PLA, ABS or Nylon. Builders who require a larger nozzle for faster throughput or who print abrasive composites should choose a different diameter or material.

0.2mm nozzle diameter

This single dimension determines the minimum feature size and layer resolution possible on the printer. A smaller bore increases detail but reduces maximum flow rate, so the buyer must match the nozzle to the intended print quality and speed.

How it compares

Measured against everything we stock in Spray Nozzles & Pressure Wands, at today’s prices. Recalculated every night.

Price $5.99
Cheaper than about 94% of the 53 comparable items (median $15.99).

Specifications

Product
Brand nameUnique Bargains
Product typePattern

Questions about this item

Does the pack of five M6 brass nozzles include any tools for installation?

The pack contains only the five brass nozzles. A spanner and socket screwdriver are needed to hold the heat block and swap the nozzle, but they are not included.

When would I choose the 0.2 mm diameter over a larger size?

The 0.2 mm nozzle suits fine-detail prints with 1.75 mm filament. It extrudes thinner lines than larger diameters, so layer height and print speed must be reduced accordingly.

How does the 0.2 mm bore affect the temperature I should set for PLA or ABS?

Use the same hot-end temperatures — 180–220 °C for PLA and 240–280 °C for ABS — but expect lower volumetric flow, so print slower or raise temperature slightly within those ranges.

More in Spray Nozzles & Pressure Wands

Similar items