Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends a 12VHPWR connection to three 8-pin PCIe plugs using 16AWG tinned copper wire rated for 600 W over 30 cm
The Vszerda 16-pin to 3×8-pin cable extends a native 12V-2x6 connection for RTX 3090 Ti, 4070 Ti, 4080 and 4090 graphics cards. It bridges the PSU’s existing 8-pin leads to the GPU’s 12+4 socket without replacing the factory harness. Builders who need a longer reach for clean routing will find the 30 cm length useful. This adapter does not fit the 12-pin connector found on RTX 3080 or 3090 models.
Sixteen AWG tinned copper conductors carry up to 600 W while resisting oxidation over time. The sleeved jacket and four included acrylic combs keep the three 6+2 branches aligned for tidy cable management. A keyed 12+4 male plug seats securely into the GPU, and each 8-pin female end accepts standard PSU cables. The design adds no active components, so signal integrity relies on the existing power delivery chain.
The cable is rated for 600 W total output across the three 8-pin connectors. If the graphics card draws more than this figure under load, the extension becomes the limiting factor. Verify the GPU’s maximum board power before installation.
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable is rated for up to 600 W, so the 12VHPWR connector will not deliver more than that in practice.
The 30 cm length and included acrylic combs let you route the 16-pin plug and three 6+2-pin sockets in tight GPU bays.
Seat the 16-pin male fully into the GPU until it clicks, then attach each 8-pin female to the PSU cables; the common mistake is leaving the 12VHPWR latch unlatched.
More in Internal PSU & Riser Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?