Vszerda 18AWG EPS 8-Pin + PCIe 8-Pin Extension Cable Kit 30cm Black

18AWG EPS & PCIe Extension Kit

This kit provides one 8-pin EPS and one 8-pin PCIe extension cable built with 18AWG conductors and a 3 mm high-density sleeve. The 30 cm length suits compact or full-tower builds where the stock cables fall short. Both extensions use a male 5557 to female 5559 interface for direct connection to the power supply cables. The heat-shrink-less design keeps the profile slim for tight routing.

Check PSU connector layout and clearance

Verify that your power supply uses standard 8-pin EPS and PCIe outputs with the 5557 pin arrangement before ordering. Measure the routing path from the PSU to the motherboard and graphics card to confirm the 30 cm reach is sufficient. Ensure the case has enough space behind the motherboard tray for the pre-bent 180 degree cable profile. The stiff yet flexible sleeve requires a gentle bend radius to avoid kinking.

Included combs enable clean cable runs

Two cable combs per extension lock the individual wires into a flat, uniform ribbon that stays aligned through sharp bends. The pre-bend 180 degree geometry means the upper wires are slightly longer, so the bundle lays flat when folded back on itself. This eliminates the tangled look of loose sleeving and simplifies routing behind the motherboard tray. No additional software or adapters are required.