We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular hub in a clear case with two rows of eight fan and ARGB headers and a SATA power connector

Vszerda

Vszerda ARGB PWM 2-in-1 8 Way Hub SATA Power internal power cable

SKU CH-GPHJ-F2D1R

Hub combines eight 5 V addressable RGB headers and eight 12 V PWM fan headers, powered by a SATA 15-pin connector with 1.3 ft motherboard sync cables included

  • Connect up to eight addressable RGB devices via 5 V 3-pin headers
  • Power eight PWM fans from a single SATA 15-pin connector
  • Motherboard ARGB sync activates automatically when the 3-pin cable is attached
  • 3 ft PWM and ARGB motherboard cables included for flexible routing
  • Adhesive tape on the rear secures the hub inside the chassis

8-Way ARGB and PWM Hub with SATA Power

This hub combines an eight-port addressable RGB splitter and an eight-port PWM fan splitter in a single unit. It draws power from a PSU SATA connector to reduce load on the motherboard headers. The PCB is housed in a PMMA case with adhesive tape on the back for secure mounting inside the chassis. It is designed for builders who need to synchronise multiple ARGB fans and strips from one motherboard connection.

Suits single-colour ARGB ecosystems.

The hub works only with 5 V 3-pin addressable RGB headers and 12 V 4-pin PWM fan headers. It cannot drive 12 V 4-pin RGB components and connecting those may cause damage. Builders using older 12 V RGB strips or fans should look at a different controller. Users who need independent speed or lighting control per port will also need a separate solution because all eight ports share one signal.

Bundled cables enable motherboard sync

A 1.3 ft 3-pin ARGB cable and a 1.3 ft 4-pin PWM cable are included to link the hub to the motherboard. The ARGB lead activates automatic motherboard synchronisation so lighting effects match the board software. The PWM lead provides RPM feedback for one fan channel while the remaining fans follow the same duty cycle. The SATA power lead connects directly to the power supply.

How it compares

Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.

Price $12.99
Cheaper than about 60% of the 7,839 comparable items (median $14.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

What power connector from the PSU does this hub require?

The hub draws power from a standard 15Pin SATA connector on the power supply unit.

Can I mix 3-pin and 4-pin fans on the eight PWM ports?

Yes, the splitter supports both 3-pin and 4-pin fans; 3-pin models will run at full speed while 4-pin fans allow PWM control.

How do I verify the ARGB sync is active after connecting the motherboard cable?

Connect the 1.3FT 3-pin ARGB lead to a 5V addressable header; the lighting across all ports will then follow the motherboard software automatically.

More in Internal PSU & Riser Cables

Similar items